Features

• 1 MHz to 500 MHz
• Individually Calibrated
• Rugged Construction
• Split Type Clamp-on Design
• MIL-STD-461 CS114, CS115, CS116
• Meets ISO 11452-4 and IEC 61000-4-6

Product Details

Injection Current Probes are used to inductively couple large RF currents into conductors passing through their aperture. The conductors are signal, control and power circuits of equipment under test for conducted susceptibility or immunity. This injection current probe is used to couple large RF currents from 1 MHz to 500 MHz. The CW input power rating of this injection current probe is 200 watts for a duration of 30 minutes.

An injection current probe acts as a multiple turn primary and a single turn secondary transformer, when placed around a power line or signal lead. Thus it provides a (nominal) 50ohm load to the susceptibility signal source, while providing a lower susceptibility signal source impedance when placed in series with the cable under test. An injection current probe is characterized by its insertion loss (dB). The insertion loss describes the inefficiency of the clamp relative to direct injection into a 50ohm circuit.

RECOMMENDED ACCESSORIES

CPF-630 - Current Probe Fixture

Injection Probe calibration fixtures are a part of the test equipment required by most of the Bulk current Injection Test Procedure Specifications. The Calibration Fixture allows the user to quickly and easily calibrate the injection probe prior to performing the compliance testing. It exceeds DO-160, Section 20 VSWR fixture requirements for stand-alone injection probe calibration fixture.

SAC-213 - 3 Meter N/N Cable

3 Meter RF cable with N(m) to N(m) connectors. Custom lengths can be made to suit your specifications.

SPECIFICATIONS